Fuel filter, a bit more involved.

At the top of the filter theres 3 pipes going to the filter, the two pointed out are push in clips

Push down on the clips and pull back on the pipe

Theres a multi plug connector, and a winged white plug, pull up on the tab and slip off the connectors


The filter housing is held in by two 8mm bolts

Once you've the filter housing and filter out you've to separate them, three torx T20 bolts hold it to the body and youve a tab to turn clockwise to release


once you've it separated it should look like this, again compare it to the new filter

Replace the seal and refit the filter in its housing and body, once youve done this you'll have to prime the diesel pump, as pointed out below, you've to manually pump it until it gets hard, once the pump becomes hard and not returning you know the filter is full.
